Oil Reclamation and the GlobeCore Oil Reclamation Process

GlobeCore is an Oil Reclamation and Oil Purification equipment manufacturer and produces equipment that perform the industry leading oil reclamation process.
Oil that is intended for use in electric power transformers is purified, degassed, and dehydrated. Cleaning mainly removes mechanical impurities, sludge, and water and moisture from the oil.  The GlobeCore Process also removes these contaminates and water from the core, windings and insulating paper completely stopping the paper degradation process.
The GlobeCore line of equipment for oil filtration, oil purification and oil degassing as well for reclamation of transformer oils are the most “in demand” models for the “recovery” and restoring of oil and fluids that have partially or completely lost their performance characteristics in the industry today.
Having a proper oil filtration and oil reclamation system as part of your transformer maintenance equipment will extend the life of your transformers and the overall efficiency of your operation, saving you time and money.

Oil fiiltration: CMM series

Capacity is from 1 v3/h to 10 m3/h.

This mobile oil processing unit is designed for degassing, removal of solids, thermal vacuum drying and heating of oil for power transformers with voltage up to 1150 kV. Capacity is from 1 v3/h to 10 m3/h. This unit can process Oils with viscosity of no more than 70 cSt at 50С.
CMM-M mobile oil units are designed for the following processes:

  • Drying to less than 10 ppm moisture content;
  • Degassing to less than 0.1% volumetric gas content;
  • Increase of oil breakdown voltage to 70 kV;
  • Drying of electrical equipment while purifying the oil;
  • Initial filling of electrical equipment with insulating oil;
  • Nitrogenation of transformer oil;
  • Pulling vacuum on transformers and other electrical equipment.

Oil Purification:  CMM Series (Oil Reclamation Process from Mechanical Particles Only)

Capacity form -16 v3/h to 6 m3/h.

The CMM oil units are designed for removal of solids and moisture from electric insulation oil with viscosity of no more than 70 cSt at 50С.  The units are used for installation, repairs and operation of oil filled, high voltage equipment (power transformers, high voltage switches etc).  The units may be used for heating of oil containing electric systems with hot oil, vacuum drying of transformers and vacuumizing.  The units can be used by installation, repair and operating facilities related to transformer servicing and maintenance.  The units are assembled on a frame, supporting the units’ components: input and output oil pumps, electric control cabinet, vacuum chamber, coarse and fine cartridge filters, vacuum pump and pipelines with valves.

Oil Reclamation Process Units: CMM-R series (full oil regeneration)

(Using Fuller’s Earth sorbent materials)

The CMM-R (Portable units for oil reclamation process) units are designed to extend life time of transformers by restoration of dielectric strength and chemical composition of the dielectric insulating oil.  In the process of oil restoration, the unit removes the products of oil decomposition and acidic materials, improves oil color, increases its stability to oxidation and lowers gas solubility.
Capacity of the CMM-R units is defined by two parameters: (1) liters per hour rate (L.P.H.) and (2) the amount of oil in liters passed through the Fuller’s Earth.  The approximate volume of reclaimed oil is 4 liters per 1 kg of Fuller’s Earth at acid number 0.2mg KOH/g.  The amount of oil treated per 1 kg of Fuller’s earth increases proportionally to the decrease of the acid number.[:]

    GlobeCore

    LEAVE A MESSAGE111